SPECIFICATIONS

Charging Voltage: 6V

Control Channels: 4 channels

Controller Mode: MODE2

Design: Cars

Features: Remote Control

High-concerned chemical: None

Is Batteries Included: No

Is Electric: No Battery

Material: Metal,Plastic

Model Number: LT360

Package Includes: Original Box,Operating Instructions,Remote Controller,USB Cable

Power: 36CC

Recommend Age: 14+y

Remote Control: Yes

Remote Distance: 150M

Scale: 1:5

State of Assembly: Ready-to-Go

Type: Car

Item No.: LT360 2024 Version

Material: ABS Plastic+Metal
Power System: 36CC Single-cylinder air-cooled two-stroke four-point fixed gasoline engine
Servo: 60KG full metal gear throttle servo
60KG metal gear steering
Remote Control: 2.4Ghz, 6CH
Remote Distance: About 200 Meters
Battery: SC6V, 4500mah (Built-in)
Remote Controller Battery: 4XAA (Not Included)
Axle Track: 525mm
Wheelbase: 615mm
Car Size: 965x527x311mm

Features

1. 36cc Single Cylinder Air-Cooled Two-Stroke Four-Point Fixed Gasoline Engine.
2. Dimensions (Length x Width x Height): 965x527x311mm.
3. Wheelbase: 440mm.
4. Axle Distance: 615mm.
5. Dominator Side Exhaust Pipe.
6. 800cc Ultra-Large Capacity Fuel Tank.
7. Four-Wheel Drive Shaft Drive System.
8. Front, Center, and Rear Differential System.
9. Differential Dual-Disc Brake Mode.
10. Front CVD Transmission Half Shaft, Rear Axle-Type Transmission Half Shaft.
11. Power Output Front Short Drive Shaft, Rear Long Drive Shaft.
12. New Structure Center Differential Bracket.
13. Metal Clutch Cup Support Cover.
14. RC-X6 6CH remote controller.
15. 60KG Metal Gear Throttle Servo (Equipped with CNC Metal Servo Arm).
16. 60KG Metal Gear Steering Servo (Equipped with CNC Metal Servo Arm).
17. 6V 4500mAh NiMH Battery.
18. 7mm Hydraulic Shock Absorber.
19. Front and Rear Anti-Roll Bar Set.
20. 5mm CNC One-Piece 6061T6 Aluminum Alloy Hard Anodized Chassis.
21. PC Material Separate Car Shell.
22. Easy-to-Remove Full Protective Roll Cage.
23. High-Performance Shredder Off-Road Tires.
24. 8000 RPM Wear-Resistant Clutch.
25. Metal Front and Rear Shock Absorber Bracket.
26. New Ratio Pot.

Notes

Please charge the new car upon receipt, as the first charging time may be longer.
Wait for the battery to cool down or charge for about half an hour after playing the car. Stop charging in about half an hour after fully charged.
Do not store the battery in a low power state. If the battery will be not used for a long time, it is recommended to charge it every 45 to 60 days, which can effectively extend the battery's service life. (Do not play with the car in a low power state, as it can easily cause loss of control and irreversible damage to the battery). The usage time of batteries is affected by temperature, and the battery capacity and power limit will decrease when the temperature is low.
Important, important, important!!! When charging: Be sure to maintain a safe distance from people and flammable and explosive materials, and charge in the presence of personnel. If you need to leave, please stop charging first.
Regarding running in:
Please run in the gasoline remote control car product before using it. When we first receive the new car
Firstly, charge the car battery (power supply for electronic devices).
Secondly, mix the oil according to the level of the engine oil. The outer packaging of general engine oil will have proportional instructions and level markings. Rofun original FD grade oil mixing ratio is between 1:40 and 1:50, the market mostly uses FB grade blending ratio of around 1:25.
Thirdly, first perform a static run in of a box of oil, and within 3-5 minutes, you can pull the middle and high speeds to reduce the generation of carbon deposits. After static running in one box of oil, jogging another box of oil will complete the entire running in process. During the process of jogging and running in, it is important to avoid climbing large skin or pulling at high speeds.
Fourthly, operating a gasoline remote-controlled vehicle should be done outdoors in open spaces. Avoid using in crowded areas, especially with the elderly and children. To avoid danger caused by improper operation.